The 2120AB-M3 model is special designed for small crafts making, even for some small casting, it is super clear, easy to use, fast dry and yellow resistance.
Part A | Part B | |
Color | Transparent | Transparent |
Viscosity | 500~2000cps | Max 100 cps |
Gravity | 1.15 | 0.96 |
Pot Life | 20 Mins | |
Curing time | 6-8 H | |
Hardness | Shore D 82 | |
Shelf Life | one year | one year |
Operation
1, Weigh Part A and Part B according to the given weight ratio/volume ratio into the prepared cleaned container, fully mixed the mixture again the container wall by clockwise, place it along for 3 to 5 minutes, and then it can be used.
2, Take the Part A and Part B according to the usable time and dosage of mixture to avoid wasting. When the temperature is below 15 ℃, please heat the part A to 30 ℃ first and then mix it to the Part B (Part A will be thicken in low temperature ); The lid of the RESIN and HARDENER bottle must be sealed closely after use to avoid rejection caused by moisture absorption from the air.
3, When the relative humidity is higher than 85%, the surface of the cured mixture will absorb moisture in the air, and form a layer of white mist in the surface, so when the relative humidity is higher than 85%, is not suitable for room temperature curing, suggest to use the heat curing.
Caution
1,The operating environment should be ventilate and should keep away from fire. Closely sealed after use.
2, Avoid eye contact, in case of contact, wash with plenty of water and get medical attention immediately.
3, If contact skin, wrap with clean cloth or paper, and wash it with water and soap.
4, Keep away from children.
5, Please take a trial before application to avoid usage mistake.
Storage And Shelf Life
1, Store at the temperature of 25°C or cool and dry place. Avoid from sunlight, high temperature or high humidity environment.
2, Use up as soon as possible when opened. It is strictly forbidden to expose to the air for a long time after it is opened to avoid affecting the quality of the products. The shelf life is 12 months in the room temperature of 25°C.
A : No, this model is designed for weight ratio, you cannot use it by volume.
A : If you mix with volume ratio, it may takes very long time to cure, and the hardness will be lower than standard.
A: Yes, this model is yellow resistance.
A : If you are new to the river table, we do not suggest you to use this model, if you are very experience with the river table making, you can use this model. Just takes more time to make a river table than the special model that designed for river table making.
Standard packing is 5kgs per bottle, and 15kgs per set.
Or you can choose any kind of bottle as below:
Ultra clear 2: 1 model suitable for all kinds of small crafts, can work with silicone mold to make small jewelry, make water proof LED lamp